Table of Contents
Advertisement
Section -2 Operation and Editing
Section-2 Operation and Editing
This section will provide you with all of the information necessary to get the most out of your S-100.
Program Mode
When the S-100 is in program mode, you can move from one program to the next by either using the <Program/Data>
wheel, the optional Digitech FS-300 footswitch or incoming MIDI program change commands from another device such as a
sequencer or keyboard.
When the S-100 is in edit mode and you wish to abort and return to program mode, simply press the <Program> button.
Storing Changes
When a program has been modified, the program number will blink in the number display when the unit is in program
mode. To store changes, press the <Store> button once. The display alternates between st and the user program
location to be stored to. This simply means that S-100 is now giving you the option to store this modified version of the
program as a user program at any number from 1 to 99. At this point, you may use the <Program/Data> wheel to change
the storing position to another program number. When the target preset location (shown in the display) is correct, press the
<Store> button once again. The display will momentarily read: --
indicating that the modified program is being stored.
Selecting Effect Configurations
The S-100 provides you with five different effect configurations that allow you ultimate flexibility and versatility in effect
routing. The five configurations appear on the front panel as follows:
Effect Module Size
Effect Configuration 1 uses one effect module because both processing engines are combined for maximum processing
power. This larger module allows you to have longer delay times and more dense sounding reverbs. Effect configurations
2-5 use Half size effect modules which allow you to use two effects per program
8
C1
C2
C5
C4
C3
User Guide
S-100
Hide quick links:
Advertisement
Table of Contents
