FUTABA GY501 Instruction Manual page 31

A
SSEMBLY AND
32
When using a T9Z transmitter, set the sensitivity at the transmitter
without changing the 100% reference value. Use the following
values as the sensitivity setting standard:
When using a transmitter that does not have a gyro sensitivity
switching function, connect the sensitivity setting connector to a
vacant channel and display the GY501 sensitivity setup screen and
set the G1 and G2 gains.
Sensitivity can also be fine adjusted using the transmitter ATV
function.
5) Check the transmitter settings in the AVCS mode.
A
DJUSTMENT
- Call the T9Z GYR setup screen.
- Adjust the sensitivity when hovering to 85% at the AVCS side and
15% at the normal side.
- Set the sensitivity during flight to 70% and 30% in the AVCS and
normal modes, respectively.
- At this time, 70% is displayed on the GY501 sensitivity display when
hovering and 40% is displayed on the GY501 sensitivity display
during flight.
*1: The GY501 sensitivity becomes 0% at 50%. When set over 50%,
the GY501 operates in the AVCS mode and when set under 50%, the
GY501 operates in the Normal mode. When setting is changed 1%,
the gyro sensitivity is changed 2%.
- Set all the rudder mixing functions to INH.
- Set the hovering and flight rudder trimmers to the same position.
- Make the rudder ATV 100% at all conditions.
- Set the T9Z condition delay function to INH.