Snap-Roll - FUTABA FP-7UAF Instruction Manual

SNP

SNAP-ROLL

Avalanche and other snap rolls can
be performed by switch.
• Four snap roll directions can be
set.
R/U: Right up snap
R/D: Right down snap
L/U: Left up snap
L/D: Left down snap
• The throw of the channel 1 (ail-
eron), channel 2 (elevator), and
channel 4 (rudder) servos can be
set.
• The SAFETY mode can be set.
(Mode in which operation is not
performed when the landing gear
is down even if the switch is turn-
ed on by mistake.)
RIGHT
UP
DOWN LEFT
SNAP ROLL
• FUNCTION AND DATA SETTING
(INH: Inhibit state)
"1" to "4" is displayed
according to the
position.
1: R/U
2: R/D
3: L/U
4: L/D
F: SAFETY mode released
5L: SAFETY mode set and
ON
5F: S A F E T Y mode set and
OFF
ToDIFF
- 15 —
Press the [MODE SELECT]
Activate/inhibit mode setting
Set the mode with the
keys.
+ : Activate
-: Inhibit
Select the direction
Switch the
UP RIGHT
to the combination
of directions to be set.
DOWN
LEFT
Aileron servo throw setting
Set the flashing display to CH1
with the
Set the rate with the
keys.
(When the + and — keys are
pressed simultaneously, 100% is
set.)
Elevator servo throw setting
Set the same as
Rudder servo throw setting
Set the same as
Set for each direction of the
by repeating steps
SAFETY mode setting
Set the to CH5 with the
keys.
Set the
direction for which snap roll is
to be turned off (direction in
which landing gear is down).
Press the — side of the
keys.
SAFETY mode release
Set the to CH5 with the
keys.
Press the + side of the
keys.
To normal display mode
keys.
to
to the