FUTABA 6XA Instruction Manual page 57

2. Adjust the hovering setting value by
pressing the (+) or (–)
You may select any value between -100%
IDLE — Idle-Up
The Idle-Up function changes the response of the engine servo
below one-half throttle and disengages it from the throttle stick. Idle-up
is commonly used during autorotation or any other time you want to
keep engine speed above normal idle when pitch is reduced.
This function is turned on whenever switch E is moved to its
forward position (and the function has been activated). You can set the
fixed throttle position over a 0 to +100% range (as shown in the figure).
The smaller the selected percentage, the closer to idle you may come
when you retard the throttle stick.
Using the Idle-Up Function
1. Press one of the
MODE SELECT
until the window appears. The
IDLE
default is for the function to be inhibited.
To activate, press the
press the (+)
DATA INPUT
cause the flashing
INH
to a flashing display.
ON
keys.
DATA INPUT
buttons
key, then
CURSOR
key. This will
display to change
– 52 –
and +100%. You may return to the default
setting of 0% by pressing both
keys.
INPUT
Full
Pwr
Idle
Full
Pwr
Idle
2. Now press the (+) key to enable the Idle-
Up function. The display will show a
flashing or display, depending on
ON OFF
the idle-up switch's position.
3. Press the key once. A flashing
CURSOR
percent indicator should appear.
4. Now you can adjust the amount of Idle-
Up with the (+) or (–)
anywhere between 0 and 100% (to return
to the default 25%, press both
keys).
INPUT
DATA
50%
Low High
Throttle Stick Motion
(0 - 50%)
50%
Low High
Throttle Stick Motion
(50 - 100%)
keys,
DATA INPUT
DATA