Futaba Accessories - FUTABA 6EXAP Instruction Manual

FUTABA ACCESSORIES AND REPLACEMENT PARTS FUTABA ACCESSORIES AND REPLACEMENT PARTS (for USA)
ANT-5 Transmitter antenna.................................
NR-4J 4.8 Volt, 600 mAh receiver battery ..........
NT-8F 600B 9.6 Volt,
600 mAh Transmitter battery ..............................
FTA-8 Neck strap ...............................................
NR-4K 4.8 Volt, 250 mAh receiver battery .........
NR-4B 4.8 Volt, 1,000 mAh receiver battery.......
NR-4F 4.8 Volt, 1,500 mAh receiver battery .......
AEC-3 8" [200mm] Servo Extension ..................
AEC-14 8" [200mm] Heavy Duty Servo Extension
(for digital servos) ...............................................
AEC-11 16" [400mm] Servo Extension ..............
AEC-15 16" [400mm] H.D. Servo Extension
(for digital servos) ...............................................
Flight packs since your Futaba 6EXAP transmitter holds memories for up to six models, there is no need to purchase a Flight packs
complete radio system (including the transmitter) for every model you fly. Available separately, Futaba Flight Packs contain a
receiver, servos, switch, battery and all servo mounting hardware. Consult your dealer or the Futaba Service Center for
specific contents and order numbers.
Receiver crystals: Receiver crystals:
The receiver frequency may be changed as long as it remains within the " low " and " high " band frequency range. If your
receiver is on any channel from 11 through 35, it is a " low band " receiver and the frequency may be changed to any other
channel from 11 through 35 without having to perform any other service. Simply purchase a crystal on the desired channel,
then replace the existing crystal in your receiver with the new one. If your receiver is on any channel from 36 through 60, it is
a " high band " receiver and the frequency may be changed to any other channel from 36 through 60. To order a receiver
crystal, replace the " ** " in the order numbers below with the required channel number. (To order a receiver crystal on channel
30, order FUTL5730.)
FM Dual Conversion 72 MHz low band
FM Dual Conversion 72 MHz high band
Note: Should you ever wish to change the transmitter frequency, the transmitter must be sent to the Futaba Service Center for retuning. Note:
REPLACEMENT PARTS REPLACEMENT PARTS
FUTM5040 FUTM5040
FUTM1280 FUTM1280
FUTM1440 FUTM1440
FUTM5692 FUTM5692
FUTM1210 FUTM1210
FUTM1380 FUTM1380
FUTM1285 FUTM1285
FUTM3910 FUTM3910
FUTM4140 FUTM4140
FUTM3955 FUTM3955
FUTM4145 FUTM4145
low band (channels 11 - 35) receiver crystal . FUTL57**
high band (channels 36 - 60) receiver crystal . FUTL58**
SWH-13 Switch Harness w/charge plug .............
FSH-6X Servo arm..............................................
FSH-6S Servo arm..............................................
FSH-32 Servo mounting screws (10)..................
ACCESSORIES ACCESSORIES
AEC-16 Dual H.D. Servo Extension
(Y-connector, for digital servos)...........................
AEC-13 Dual Servo Extension (Y-connector) .....
SR-10 Dual Servo Reverser ...............................
Trainer Box transmitter........................................
(if using with 6EXA transmitter use the MD-TC trainer cord)
MD-TC trainer cord .............................................
MM-TC trainer cord..............................................
(for USA)
FUTM4370 FUTM4370
FUTM2030 FUTM2030
FUTM2010 FUTM2010
FUTM2250 FUTM2250
FUTM4135 FUTM4135
FUTM4130 FUTM4130
FUTM4150 FUTM4150
FUTM4375 FUTM4375
FUTM4420 FUTM4420
FUTM4415 FUTM4415