Machine Operation Keys - ELNA XQUISIT 2 Manual

4
A
1
2
3

Machine Operation Keys

NOTE: The presser foot must be lowered before
pressing any of these keys.
1. Up/Down Needle Key
If the needle is up when you press this key, the
needle will go down to its lowest position.
If the needle is down when you press this
key, the needle will go to its highest position.
Press the key twice to sew a single stitch.
2. Thread Cutter Key
After sewing is stopped, press this key to cut
needle and bobbin threads.
CAUTION: Use the thread cutter A on the
side of the machine for heavy or decorative
threads.
3. Reverse/Backtack Key
Press and hold this key while sewing stitches
1/01, 2/01 and 3/01 and machine sews reverse
straight stitches at a slower speed. Release the
key and machine stops.
Press and hold this key while sewing all other
stitches and machine lockstitches (backtacks).
Release the key and machine stops.
See pages 35-36 for information on how this key
operates when using the
the LCD.
4. Start/Stop Key
Operates the machine when winding bobbin and
if the foot control is not connected. (If the foot
control is connected, this key acts as a Stop key
only.) Press this key and machine sews a few
stitches slowly and then continues to sew at the
speed set with the speed control lever. Press
key again to stop machine.
Key changes color to show operating status.
Green: Machine ready to sew or sewing
Red: Machine is not ready
Orange: Machine is winding bobbin
and keys on
11