Attach And Remove Foot Holder; Adjusting Foot Pressure; Seam Allowance Lines - ELNA XQUISIT 2 Manual

A
B
1
2
120 o
90 o
60 o
3
45 o
1
3
2
3/8 3/4
1/2 7/8
1 Inch
5/8
10 20 mm
15 25
Attaching and Removing the Foot Holder
Turn handwheel or press the
raised. Raise presser foot. Turn off power/light
switch.
Turn the screw 1 counterclockwise with the
screwdriver and remove foot holder.
To attach:
A. Place foot holder on needle bar and turn screw
clockwise to tighten. OR
B. Match the hole in the holder 2 with the hole in
the presser bar 3. Put screw into hole. Turn
screw clockwise to tighten.

Adjusting Foot Pressure

There are three settings available for pressure. The
weight and characteristics of your fabrics may
require less pressure than the standard "3"
pressure.
1. Turn off power/light switch.
2. Open face cover.
3. Insert screwdriver.
4. Turn screw counterclockwise only to adjust
foot pressure.
5. Remove screwdriver.
6. Close face cover.
7. Turn on power/light switch.

Seam Allowance Lines

The lines on the needle plate help you measure
seam width.
The number indicates the distance between the
1 center needle position and the seam allowance
line.
Angle lines provide accurate measurements for
aligning small fabric pieces when quilting.
1 Millimeters
2 Inches
3 Angle lines
key until needle is
9