Connecting The Machine To The Power Supply; Foot Control - ELNA 120 Instruction Manual

q y
w
r
e

Connecting the Machine to the Power Supply

Before connecting the power cord, make sure the
voltage and frequency shown on the machine
conform to your electrical power.
1. Turn off the power switch.
2. Insert the machine plug into the machine
socket.
3. Insert the power supply plug into the outlet .
4. Turn on the power switch to turn on the power
and sewing light.
q Power switch
w Outlet
e Machine socket
t
r Machine plug
t Foot control
y Power supply plug

Foot Control

Sewing speed can be varied by the foot control.
The harder you press on the control, the faster the
machine runs.
Caution:
Do not place anything on the foot contorol,
otherwise the machine will start advertently.
WARNING:
While in operation, always keep your eyes on the
sewing area, and do not touch any moving parts such
as the thrad take-up lever, handwheel or needle.
Always turn off the power switch and unplug from the
power supply:
– when leaving the machine unattended.
– when attaching or removing parts.
– when clearning the machine.
Do not place anything on the foot control, otherwise the
machine will run intermittently.
4