TECHNICAL GUIDE
Installation positions • Lubrication points • Remarks
Reassembling the exterior parts (1)
Set the battery.
1. Slide the battery in the direction shown by the arrow in the illustration (with the positive side facing up.)
2. Attach the clip to the battery holder.
* If the clip of the battery holder is attached to the main plate, take it off.
Reassembling the exterior parts (2)
Set the dial.
Positions of the slots on the main plate
(two positions)
Reassembling the exterior parts (3)
Set the hour hand, minute hand and second hand.
16
1. Check the two positions of the slots on the main
plate and the position of the calendar frame of the
dial. Place the dial temporarily.
2. Align the dial properly and firmly press it down to
set it.
How to set the hour hand
1. Pull out the crown to the second click position and turn it
clockwise to advance the hour hand. Stop the hour hand at the
moment the date changes.
2. Set the hour hand pointing to the 12 o'clock position.
• Press it down to the surface of the hour wheel.
• Exercise care so as not to damage the arbors of the minute
wheel and fourth wheel.
3. Make sure that there is no friction between the hour hand and the
dial. Adjust the height of the hour hand if necessary.
Clip of the battery holder
Cal. 6A32A