Seiko 6A32 Parts Catalogue /Technical Manual page 11

TECHNICAL GUIDE
Installation positions • Lubrication points • Remarks
Reassembly (5)
Reassemble the circuit block
spacer and winding stem
switch lever.
Note 1
Installation position of the 24-H arbor
Place the 24-H arbor in the position where it does not cover
the holes indicated in the illustration on the left, as the
switch pins of the circuit block will be inserted into those
holes.
Note 2
Remarks on installation of the winding stem switch lever
Make sure that the winding stem switch lever does not
overlap the tip of the winding stem switch lever spring.
❇ Install the parts in the number order shown in the illustration below,
paying attention to the following:
mounting positions,
direction of mounting,
type of oil, lubrication point(s) and amount of lubrication.
normal quantity
1 Circuit block spacer
2 Circuit block spacer
3 24-H arbor
Refer to the Note 1 below.
Avoid moving the movement after
installing the spacers, as the spacers
are not yet fastened and they can
easily drop off.
4 Winding stem switch lever (AO-3)
Refer to the Note 2 below.
Cal. 6A32A
11