Headlight Replacement - Hoover U5018 Owner's Manual

Secondary and final
filters
3-4
Cleaning secondary filter
Disconnect cleaner from electrical
outlet.
The secondary filter (A), located in
the bottom of the bag compartment,
protects the motor from dirt parti-
cles.
If filter becomes dirty, slide filter out.
Hand wash filter in cold water with
mild detergent, then air dry.
Slide dry filter into slot.
Should you want to replace this fil-
ter, ask for HOOVER part No.
40110004.

Headlight replacement

What to buy
This cleaner uses a 13 volt, T-3 114 wedge base bulb,
Hoover part No. 27313107.
3-6
Removing lens
Disconnect cleaner from electrical
outlet.
Press handle release pedal and
place handle in low position.
Using a Phillips screwdriver, remove
the two screws as shown and lift off
lens.
8
3-5
A
Cleaning final filter
The final filter assists in the filtration
process to return clean air to the
room.
Disconnect cleaner from electrical
outlet.
To remove this filter when it be-
comes dirty, remove bag door.
Lift out filter (B) and hand wash it in
cold water with mild detergent.
Let filter air dry and reposition it on
the cleaner. Replace bag door.
Should you want to replace this
filter, ask for HOOVER part No.
40110004.
Do not operate cleaner without
either the secondary or final filter
in place.
3-7
Installing bulb
Pull old bulb straight out of socket.
Push new bulb straight into socket
until locked in place.
Excessive force is not required.
B
3-8
Replacing lens
Reposition lens and secure with the
two screws.