Check Bag Indicator - Hoover U5018 Owner's Manual

Upright vacuum cleaner
Table of Contents

Advertisement

2-10
A
Removing hose
When using cleaning tools, cleaner
handle should be in the upright
position. Also, turn cleaner OFF
before disconnecting and con-
necting hose to hose tube (A).
To use hose, lift hose end as shown.
When you are finished cleaning with
the tools, reposition hose end into
tube.
Extra reach hose
(available at additional cost)
The extra reach hose provides easi-
er cleaning of stairs and hard to
reach places. Follow the steps
below for attaching and detaching
the hose.
2-13
2-14
H
I
Turn cleaner OFF before discon-
necting and connecting hose.
Remove hose end from cleaner
base. Align end of extra reach hose
with projections (H) over slots (I) on
end of attached hose.
Slide hose into slots and twist hose
to lock it into place (To detach hose,
reverse procedure).
Attach wands or tools to the other
end of hose.
6
2-11
B
Attach wand and tools
Attach tool or wand to the hose (B).
Attach tool to wand (C) by pushing
it firmly onto the wand.
Twist wand or tool slightly to tighten
or loosen the connection.
2-15
J

Check bag indicator

The indicator (J) will begin to show red
as the filter bag fills with dirt.
There are three conditions that will
cause the indicator to become com-
pletely red:
1. If the bag is full; change the bag.
2. If very fine materials have been
picked up, clogging the bag pores;
change the bag.
3. If there is a blockage in the nozzle,
hose, tools or at the bag opening;
remove the blockage (see "Clearing
blockages" section).
2-12
C
Select proper tool
D. Dusting brush may be used for
carved furniture, table tops, books,
lamps, lighting fixtures, venetian
blinds, baseboards, shutters, and
registers.
E. Furniture nozzle may be used
for upholstered furniture, draperies,
mattresses, clothing, automobile
interiors, and carpeted stairs.
F. Crevice tool may be used in tight
spaces, corners and along edges in
such places as dresser drawers,
upholstered furniture, stairs and
baseboards.
G. Wands are used to give extra
length to your hose. Use them with
any of the above tools.
E
D
F
G

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents