Replacing Headlight; Headlight Replacement - Hoover UH40080 Owner's Manual

Cleaning final filter
3.12
A

Headlight replacement

What to buy
This cleaner uses a 12 volt, wedge base type
912 bulb, Hoover part No. 27313107.
3.13
A
3.15
Using a flat screw-
driver, pry off hood
as shown and
remove .
B
Disconnect cleaner
from electrical
outlet.
Step on handle
release pedal and
place cleaner in the
lowest position .
Turn cleaner over .
Using a Phillips
screwdriver, remove
the two screws (A)
located nearest the
wheels at the rear
of the base of the
cleaner .
3.16
Install bulb - Pull
old bulb straight
out of socket . Push
new bulb straight
into socket until
locked in place
Excessive force is not
required.
The final filter assists in returning clean air
to the room .
To remove this filter when it becomes dirty,
lay handle flat on the floor . Press door tab
(A) and remove door .
Lift out filter (B) and hand wash it in cold
water with mild detergent .
Let filter air dry and reposition it . Replace
door . Snap closed .
Should you want to replace this filter, ask
for HOOVER part No. 40110009 or service
38766028.
Do not operate cleaner without the filter in
place .
3.14
Turn cleaner over . Remove HOOVER®
emblem (B) . Using a Phillips screwdriver,
remove the screw (C), located underneath
the emblem .
3.17
A
Actual model may vary from images shown.
11
B
Replace hood
Reposition hood,
fitting tabs (A)
on either side
under the lens
cover as shown .
Replace screw and
HOOVER® emblem .
Turn cleaner over
and replace the two
screws located on
the bottom of the
cleaner as shown in
Fig . 3 . 1 6 .
C