Polarized Plug; Check Bag Indicator; Handle Positions - Hoover TurboPOWER WindTunnel S3646 Owner's Manual

Push the hand grip (G) down onto wand
so that the button projection (H) fits
into the slot. Push the latch to the lock
symbol to secure wand.
Push plug on power nozzle cord com-
pletely into receptacle underneath
hand grip.
Always disconnect cleaner from
electrical outlet before attaching or
removing power nozzle plug.
2-4

Check bag indicator

The indicator will begin to show red as bag
fills with dirt. There are three conditions
that will cause the indicator to become
completely red:
1. The bag is full; change the bag.
2. Very fine materials (such as powder)
have been picked up, clogging the bag
pores; change the bag, even if it is not full.
3. There is a blockage in the nozzle, hose,
tools, or at the bag opening; remove the
blockage.
2-2
B
A

Polarized plug

To reduce the risk of electric shock, this
appliance has a polarized plug (one
blade is wider than the other). This plug
will fit in a polarized outlet only one way.
If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit,
contact a qualified electrician to install
the proper outlet. Do not change the
plug in any way.
2-5
Deluxe power
nozzle

Handle positions

The handle has two positions when
used with the power nozzle: upright and
operating.
To lower handle to operating position,
place your foot firmly on the power
nozzle and pull handle back.
2-3
ON-OFF switches
After assembling cleaner, plug cord
into electrical outlet. Turn cleaner on by
depressing ON-OFF pedal (A). To turn
cleaner off, depress pedal again.
Note: Pedal opposite ON-OFF pedal is
Cord Rewind Pedal (B).
On some models two switches are
used to turn the cleaner on for opera-
tion.
Press remote control switch (C) on hand
grip to the "OFF" position before plugging
cord into electrical outlet.
Plug cord into an electrical outlet and
step on ON-OFF pedal. The POWER
ON light will glow, indicating that the
cleaner can then be controlled at the
hand grip. Press hand grip switch to the
ON position.
2-6
Floor surface selector
Carpet or rug cleaning
When using the power nozzle for carpet
and rug cleaning, push the floor surface
selector button toward "RUG" (D). This
setting provides the suction and agitator
action necessary to deep clean carpets.
The nozzle adjusts automatically to vari-
ous carpet pile heights.
C
D
5