Assembly; Product Specifications; Selecting The Cutter Bit - Craftsman 17540 - 9.5 Amp 1-3/4 HP Plunge Base Router Operator's Manual

Rating
No4oad Speed
Peak HP
Inpul
Cogets!Nule and Culler BitShank Otamators
Plunge Base Dtameler
Su b Base Opening (Dtameler forculter b|t use)
Sub Base Thickness
.................,,,, ,,, ,,, ,,, ..... , , ,
PlungeBase Depth of Cut
9.5 Amps
2'5,000 RPM
1_I_
12D-voile.6OHz.AC
lt4-tn, l12-tn,
6_llE-Inches
1 t/_-|nches
o,23-=,_hes C6rnm)
2 Ve-tnches(55ram)
NOTE=This tool Is ehlpped completely assembled.To Install or remove bits
or add accessories such as sawdust ejection hoods for hook-up to vscs, see
the following Instructions,
SELECTING THE CUTTER BIT
This router comes wilh 1/4-In, and It24n. collate/nutsthat accept 1/4 and ll2-lnch
diameter shsnked ,,::tilter blte_
Z_ WARNING: Do not use router cutter bits that have a cutter bit dlsmstsr
larger than 1 _h-lnchss as they will not fit through the sub-base openlng_ and
will cause damage to the sub"base, the motor, and could cause serious personal
Injury to the operator.
NOTE=The sub-base Installed on this router has an opening of t_14.lnches,
To use cutting bits with a larger dlsmetsr, use s subbase with a larger opening,
sold separately at Sears stores or other Craftsman outlets.
Z_ WARNING: ALWAYS tum motor off and unplug router before maldng any
adjustments or Installing sccessorfes. Failure to unplug the router could result
In accidental starting which can cause serious peraonsl Injury.
14