Internal Routing With Plunge Base - Craftsman 17540 - 9.5 Amp 1-3/4 HP Plunge Base Router Operator's Manual

EDGE R OUTING OR INTERNAL ROUTING cont.
/_ WARNING: Re=movingcutter bit from workplace while= It ta stlll rotating
could de=me=g+= workplace end result In loss of eonlrol, c+=uelng serious personal
Inlury_
NOTE: Making teat cuts In scrap m+=tertalthat I+= +=lmll+=r to your workpl+=ce I+=
essential. Learning how the router'+=speed, depth-of._ut end cutter bit wilt rea+=t
In the= workp!+=cewill help you produce qu+=llty cuts.
INTERNAL ROUTING WITH PLUNGE BASE (Pigs. 13 end 13a)
t_ With depth.of*cut set, end the plunge ectlon Iocked In ther+=!s+=d (Up) position,
turnmotor "On++=nd let motor build up to its full speed (sea Fig, 13)_
2. To begin your cut, unlockthe= plunge= lock leverand gentiylower the plunge acgon
down evenly Into theworkpl+=c+= (s+=+= Rg. 13a).
Edge l
Gu,do ] ,
Feed Direction
,3+ When the de=sired deplh-of.cut Is achieved, lock the plungeIock lever (Down) end
proceed to make your cut (ace Rg, 1ga).
4,, When cut +s c+=mpleted, turn motor _O_ and i+=t cutter bit come to a couple=t+= stop.
5, When cutt+=rbitcomes to a compl+=te s top, unlockptung+= f +=ck l+=v+=r (Up) +=nd plunge=
action will eutem+=tIcat_y retract _tter bit from w+=rkplee+=,
Z_ WARNING: Removing cutter bit free workplace while It I+= still rotating
could damage workplace +=nd result In loss of control, ceuelng serlou+=personal
Injury,
6. Unplug router frompower scums, place roular on worktable, Inspect finishedcut
In workplace
_ WARNING: Always securely clamp your workplace and keep a firm grip
on the router base with BOTH HANDS at all times. Failure to do so could result
In los+=of control causing po+=slbta serious personal Injury,
23