Delta 33-891 Instruction Manual page 24

IN-RIPPING
C
In-ripping involves all of the general conditions stated
B
under RIPPING. The yoke is clamped at right angle to
the track arm with the blade guard facing the rear of the
machine. The cuttinghead is positioned on the in-rip
scale to the desired setting and clamped in position. The
workpiece is fed from the right side of the saw. Fig. 66,
shows a typical in-ripping operation on the radial saw.
Note the push stick is being used due to the narrow
workpiece.
Fig. 66
24