A P P E N D I X C Configuring The Switch With The Cli-Based Setup Program; Accessing The Cli Through The Console Port; Taking Out What You Need - Cisco WS-C2940-8TT-S Hardware Installation Manual

Taking Out What You Need

After you have entered the configuration information for the switch, save it to flash memory by using
the write memory privileged EXEC command.
While in Express Setup mode, the IP address 10.0.0.1 remains active on the switch until you enter the
Note
write memory command. You lose the Telnet connection after entering the write memory command.
For more information about using the CLI, see the command reference for this release.

Accessing the CLI Through the Console Port

You can access the CLI by connecting the console port of the switch to the serial port on your PC or
workstation and access the switch through a Telnet session. To access the switch through the console
port, follow the steps in the rest of this chapter, beginning with the
on page

Taking Out What You Need

Remove the items from the shipping container, as shown in
Figure C-1
1
2
3
1
2
Catalyst 2940 Switch Hardware Installation Guide
C-2
C-2.
Catalyst 2940 Switch, Console Cable, and AC Power Cord
SYS T
1x
STA T
2x
3x
DPL X
4x
5x
SPD 6x
7x
8x
MO DE
Switch 3 AC power cord
Console cable
Appendix C Configuring the Switch with the CLI-Based Setup Program
Figure
C at al ys t 29
40
SE RIE S
1
"Taking Out What You Need" section
C-1.
OL-6157-01