Configuring the Switch with the CLI-Based
Setup Program
This appendix provides a command-line interface (CLI)-based setup procedure for a standalone switch.
This chapter contains these sections:
•
•
•
•
•
•
•
•
Methods for Accessing the CLI
You can access the CLI by these methods:
•
•
Accessing the CLI Through Express Setup (Unconfigured Switch Only)
You can access the CLI on an unconfigured switch by placing the switch in Express Setup mode and then
connecting an Ethernet port of the switch to the Ethernet port of your PC or workstation. To put the
switch into Express Setup mode, follow the steps described in the getting started guide.
After the switch is in Express Setup mode, telnet to the switch by using the IP address 10.0.0.1, and enter
the setup user EXEC command. See these sections in this chapter to then configure the switch by using
the CLI:
•
•
OL-6157-01
Methods for Accessing the CLI, page C-1
Connecting to a Power Source, page C-3
Where to Go Next, page C-8
Accessing the CLI Through Express Setup (Unconfigured Switch Only), page C-1
Accessing the CLI Through the Console Port, page C-2
Entering the Initial Configuration Information, page C-5
Completing the Setup Program, page C-6
A P P E N D I X
Catalyst 2940 Switch Hardware Installation Guide
C
C-1