Cable Guard; Leds; Syst Led - Cisco WS-C2940-8TT-S Hardware Installation Manual

Front-Panel Description
The Cisco CWDM SFPs operate on single-mode fiber. The SFPs support both Gigabit Ethernet as well
as fiber channel (1 Gigabit and 2 Gigabit) links. For more information about Cisco CWDM SFPs, see
the Cisco CWDM SFP Compatibility Matrix at this URL:
http://www.cisco.com/issg/tmg/cwdm.shtml#matrix
Also see your SFP module documentation and the Cisco Small Form-Factor Pluggable Modules
Installation Notes (not orderable but is available on Cisco.com).
For the latest information about SFP modules supported by the switch, see the release notes.

Cable Guard

You can order an optional cable guard to secure cables to the front of the switch and prevent them from
being accidentally removed. To order a cable guard, contact your Cisco representative.

LEDs

There are four LEDs on the left panel of the switch, and there are port status LEDs above all the switch
ports, as shown in
Figure 1-3
4
6
1
2
3
You can use these LEDs to monitor switch activity and performance:
•
•
Catalyst 2940 Switch Hardware Installation Guide
1-6
Figure 1-3.
LEDs on Catalyst 2940 Switches
3
S Y S T
S T A T
5
D P L X
S P D
M O D E
2
Port status LED
Mode button

SYST LED

The system (SYST) continually displays the system status. The SYST LED color shows the switch
status.
The status (STAT), duplex (DPLX), and speed (SPD) LEDs show the information that is being
displayed by the port status LEDs. Pressing the Mode button cycles the LEDs through the STAT,
DPLX, and SPD displays.
1
1 x
2 x
3 x
4
STAT LED
5
DPLX LED
6 SPD LED
Chapter 1
4 x
5 x
Overview
OL-6157-01