Setting Port Vid - ZyXEL Communications Dimension XGS-4528F User Manual

Since the VLAN2 network is connected to port 1 on the Switch, select Fixed to
3
configure port 1 to be a permanent member of the VLAN only.
To ensure that VLAN-unaware devices (such as computers and hubs) can receive
4
frames properly, clear the TX Tagging check box to set the Switch to remove
VLAN tags before sending.
Click Add to save the settings to the run-time memory. Settings in the run-time
5
memory are lost when the Switch's power is turned off.

5.1.4 Setting Port VID

Use PVID to add a tag to incoming untagged frames received on that port so that
the frames are forwarded to the VLAN group that the tag defines.
In the example network, configure 2 as the port VID on port 1 so that any
untagged frames received on that port get sent to VLAN 2.
Figure 23 Initial Setup Network Example: Port VID
Click Advanced Applications
1
and VLAN in the navigation
panel. Then click the VLAN Port
Setting link.
Enter 2 in the PVID field for port
2
1 and click Apply to save your
changes back to the run-time
memory. Settings in the run-time
memory are lost when the
Switch's power is turned off.
XGS-4528F User's Guide
Chapter 5 Initial Setup Example
EXAMPLE
61