Rear Panel Led Sequences - HP 330834-B21 - StorageWorks Ultrium 460 Tape Library Drive Module User Manual

LED Sequence
Drive FLASHES.
Drive, Tape and Ready
FLASH.
Drive and Ready ON with
Tape and Clean OFF.
Alternates repeatedly.
Table 8 Rear panel LED sequences
LED Sequence
All LEDs OFF.
Ready and Clean OFF.
Drive and Tape FLASH.
46
Understanding the LEDs
Cause
The drive mechanism has
detected an error.
There is a firmware download
problem.
The drive has a firmware
error.
Cause
The enclosure is not providing
auto-termination.
There has been an enclosure
failure or the cooling fan is
not working correctly.
Action required
Load a new cartridge. If the error persists,
power cycle or reset the drive.
If the Drive LED remains on, call for service.
Insert a cartridge to clear the LED sequence.
If the condition persists, call for service.
Power cycle or reset the drive.
Upgrade the firmware. If the condition
persists, call for service.
Action required
Check that the drive's SCSI cable is
connected to the SCSI-IN connector. Check
whether a terminator or other SCSI cable is
plugged into the SCSI-OUT connector. If a
terminator is connected, remove it. If another
SCSI cable is connected, make sure that the
SCSI chain is terminated at the last device.
Call for service.