Other Servers; Install Drive; Attaching Locating Screws In A Typical Hp Proliant 350 Or 370; Installing Tape Drive - HP 330834-B21 - StorageWorks Ultrium 460 Tape Library Drive Module User Manual

1. Release catch
2. Push cover back and lift off
Figure 6 Attaching locating screws in a typical HP ProLiant 350 or 370

Other servers

Attach the appropriate mounting hardware. Refer to the manufacturer's documentation for instructions.
• If you are installing on a server that requires a tray, place the tape drive in the tray.
• Some servers have snap-on mounting rails attached to the filler panel. These can be removed
and attached to the tape drive with screws.

Install drive

Slide the tape drive into the open bay, aligning the tray or rails with the slots in the bay, as shown
in Figure 7.
Figure 7 Installing tape drive
If your server does not use mounting hardware, check that the holes in the chassis are aligned with
the holes in the side of the tape drive.
Do not secure the drive at this point because you may have to move the drive to get the cables into place.
Ultrium full-height SCSI Tape Drives
25