Other Servers - HP StorageWorks DAT 72 User Manual

Mounting screws
Other HP ProLiant server models, such as ML350 and ML370, only require the use of special
locating screws with no mounting rail.
1. Use a Torx screwdriver to attach the appropriate screws. You may need to purchase the M3
screws separately. Position the screws, as shown in
Figure 5 Attaching mounting screws
1
2
• HP ProLiant ML350: Use M3 mounting screws. These have a thicker head than the standard M3
screws.
• HP ProLiant ML370: Use M3 offset mounting screws. These have a thick offset piece and a
thicker head than the standard M3 screws.

Other servers

1. Attach the appropriate mounting hardware. Refer to the manufacturer's documentation for
instructions.
• If you are installing on a server that requires a tray, place the tape drive in the tray.
• If you are installing in a server that requires mounting rails, fasten the rails to the tape drive.
• Some servers have snap-on mounting rails attached to the filler panel. These can be removed
and attached to the tape drive with screws.
M3 mounting screws
M3 offset mounting screws
Figure 5.
HP StorageWorks DAT Tape Drives User Guide
1
2
15