Automatic Gearbox Dsg - Skoda YETI - 11-2009 Owner's Manual

Automatic gearbox DSG*

Automatic gearbox DSG*
Introduction
Your car is equipped with an automatic gearbox DSG. The abbreviation DSG means
Direct shift gearbox (Direct shift gearbox).
Two independent clutches are needed for the power transmission between the engine
and the gearbox. These replace the torque converter of the conventional automatic
gearbox. Their shifting is matched in such a way that there are no jerks when shifting
the gear and the power transmission of the engine to the front wheels is not
interrupted.
Information for driving with the automatic gearbox DSG
Shifting up and down through the gears is performed automatically.
You can also, however, switch the gearbox over into the Tiptronic mode. This mode
makes it possible for you to also shift gears manually ⇒ page 124.
Starting-off and Driving
– Depress the brake pedal fully and keep it depressed.
– Press the Shiftlock button (button in handle of the selector lever), move the
selector lever into the desired position, e.g. D ⇒ page 122, and then release the
Shiftlock button.
– Release the brake pedal and depress the accelerator ⇒
Stopping for a short time
– The selector lever position N does not have to be selected when stopping just for
a short time, such as at a cross roads. It is sufficient to hold the vehicle stationary
using the foot brake. The engine can, however, be allowed just to idle.
Parking
– Depress the brake pedal and hold it depressed.
Using the system Safety
– Apply the handbrake firmly.
– Press and Shiftlock button in the selector lever, move the selector lever to P and
The engine can only be started when the selector lever is in position P or N
⇒ page 110. At temperatures below -10 °C the engine can only be started in the
selector lever position P.
It is sufficient to engage selector lever position P when parking on a flat surface. When
parking on a slope you should first apply the handbrake firmly and then move the
selector lever into position P. This is to ensure that there is no excessive pressure acting
on the lock mechanism and that it is easier to subsequently move the selector lever out
of position P.
If the selector lever position N is selected by accident while driving it is first necessary
to release pressure on the accelerator pedal and wait for idling speed of the engine to
be reached before engaging a drive position in the selector lever.
•
lever if the car is stationary and the engine is running - risk of accident!
•
accident!
•
stationary with the gear engaged by means of the "accelerator", this means by
letting the clutch slip. This can lead to overheating of the clutch. If there is a risk
.
of overheating of the clutch due to overload, the clutch is opened automatically
and the vehicle rolls backward - risk of accident!
•
prevent the vehicle from rolling back.
Driving Tips General Maintenance
then release the Shiftlock button.
WARNING
Do not depress the accelerator when changing the position of the selector
Never move the selector lever into position R or P when driving - risk of an
If you are stopping at a hill (downhill section), never try to hold the car
If you must stop at a slope, depress and hold the brake pedal, so that you can
Breakdown assistance
Automatic gearbox DSG* 121
Technical Data