Table of Contents
Advertisement
The warning light
lights up in the instrument cluster when the fog lights are switched
on page 28.
Fog lights with turning light "CORNER"* function
The fog lights with the function "CORNER" are designed for a better illu-
mination of the surrounding area near the vehicle when corning,
parking etc.
The fog lights with the function "CORNER" are adjusted according to the steering angle
or after switching on the turn signal light
the vehicle is stationary and the engine is running or it moves with a speed of
maximum 40 km/h;
the daylight driving lights are not switched on;
the low beam is switched on or the light switch is in the position
intensity of the ambient light causes the low beam to be switched on;
the fog lights are not switched on;
no reverse gear is engaged.
Note
If you engage the reverse gear during the active function "CORNER", both fog lights
illuminate.
Rear fog light
Switching on the rear fog light
– First of all turn the light switch into position
– Pull the switch into position
The warning light
lights up in the instrument cluster when the rear fog light is
switched on page 28.
8)
If both switch on versions are conflicting, for example if the steering wheel is turned to the left
and the right turn signal light is switched on, the turn signal light has the higher priority.
Using the system
Safety
8)
in the following circumstances:
page 56, fig.
or
A
.
2
Driving Tips
Only the rear fog light of the trailer lights up automatically when you are towing a trailer
using a factory-fitted towing device from Škoda original accessories which is
fitted with the rear fog light.
The rear fog light is located in the rear light array on the driver's side.
Caution
The rear fog light should only be switched on if visibility is particularly poor (conform
with any varying legal provisions) to avoid dazzling vehicles behind your vehicle.
Instrument lighting*
You can adjust the brightness of the instrument lighting.
and the
Instrument lighting
– Switch on the light.
– Turn the control dial
39.
For the information display* page 24 the intensity of the lighting is automatically
set. It is only possible to adjust the instrument lighting with the control dial if the light
intensity drops below the set value of the light sensor.
General Maintenance
Lights and Visibility
Fig. 40 Dash panel: Instrument lighting
fig. 40
to the desired intensity of the instrument lighting.
Breakdown assistance
57
Technical Data
Advertisement
Table of Contents
