Table of Contents
Advertisement
WARNING (continued)
example rain or snow. For these conditions we recommend to switch on the low
beam
!
Note
Do not affix any stickers in front of the light sensor, so that you do not impair its
function or put it out of operation.
The same principles as for using the automatic light control also apply to the light
which is switched on manually page 53.
Cornering lights*
The cornering lights are used to illuminate the curves by means of the cone of light
swiveling together with the front headlight with Xenon lights*. This function is active
when the speed of the car increases to more than 10km/h.
The swiveling function of the headlights can be switched off / on via the menu point
Assistants in the main menu of the information display* page 24.
WARNING
If the cornering lights are defective, the headlights are automatically lowered to
the emergency position, which prevents a possible dazzling of oncoming traffic.
Thus the illuminated length of the road is shortened. Drive carefully and have
the car inspected immediately by a specialist garage.
Coming Home Function
The function makes it possible to switch on the lights in the darkness for a short time
after leaving the vehicle.
Switching on Coming Home Function
– The light switch is in the position automatic driving lamp control
beam illuminates.
– Switch off the ignition.
Using the system
Safety
– After opening the driver's door, the function Coming Home is switched on.
– Close all the doors and the boot lid and lock the vehicle. After a short time, switch
Depending on equipment fitted the function Coming Home switches on the following
lights:
Coming Home Function
The lights go out 10 seconds after closing all the doors and the boot lid.
If a door or the boot lid remains open, the lights go out 60 seconds after switching off
the ignition.
On vehicles fitted with automatic driving lamp control you can also switch the light
switch in the position
sensor in the mount of the interior rear mirror. If the light intensity is higher than the
set value of the light sensor, the Coming Home Function is not switched on after
switching off the ignition.
discharged particularly in short-haul traffic.
with the legal requirements.
of the information display*.
Leaving Home Function
and the low
This function makes it possible to switch on the lights when approaching the vehicle.
Driving Tips
General Maintenance
all lights off.
Parking lights,
Low beam,
Entry lighting in the exterior mirrors,
Licence plate light.
. The function Coming Home is controlled with the light
Note
If the Coming Home Function is switched on constantly, the battery will be heavily
The switching on of the described lights should only be undertaken in accordance
You can change the illumination period for the Coming Home Function by means
Breakdown assistance
Lights and Visibility
55
Technical Data
Advertisement
Table of Contents
