Adjustment Of The Safety Partition; Emergency Unlocking Of The Loading Area Door - Skoda ROOMSTER - 03-2010 Owner's Manual

204 Praktik
You can fix the loading floor with a hook on the top edge of the boot lid cutout, in order
to e.g. reach the spare wheel*.
– Raise the loading floor at the loop
(it is located below the loading floor edge) to the top edge of the tailgate cutout
 page 203, fig. 175
on the right.

Adjustment of the safety partition

Fig. 176 Top support / bottom support of the safety partition
Only valid for some countries.
– Raise the loading floor part behind the safety partition.
– Unscrew on each side in the upper part of the body one screw
 fig.
lower part one screw 176.
– Move the safety partition into the desired position. Always ensure that it has the
same distance and the same number of holes on both sides top and bottom.
– Screw on each side in the upper part of the body one screw and in the lower part
one screw.
– Have the tightening torque of the bolts checked with a torque wrench as soon as
possible. The tightening torque must be 20 Nm.
– Fold the part of the loading floor again towards the bottom.
 page 203, fig. 175
and fix it with a plastic hook
 fig. 176

Emergency unlocking of the loading area door

If there is a fault in the central locking, you can open the loading area door as follows:
– Remove the control cable and pull it.
– Press on the loading area door, in order to open it.
– Press back the control cable again.
and in the
Fig. 177 Emergency unlocking of the
loading area door