190
Praktik
Raise the loading floor at the loop
–
located below the loading floor edge) to the top edge of the tailgate cutout
⇒ f ig. 164
on the right.
Adjustment of the safety partition
Fig. 165 Top support/bottom support of the safety partition
Only valid for some countries.
–
Raise the loading floor part behind the safety partition.
–
Unscrew on each side in the upper part of the body one screw
and in the lower part one screw
–
Move the safety partition into the desired position. Always ensure that it has
the same distance and the same number of holes on both sides top and bot-
tom.
Screw on each side in the upper part of the body one screw and in the lower
–
part one screw.
–
Have the tightening torque of the bolts checked with a torque wrench as
soon as possible. The tightening torque must be 20 Nm.
–
Change the position of the cover of the luggage compartment floor behind the
safety partition so that it lines up with the new position of the safety partition.
–
Fold the part of the loading floor again towards the bottom.
⇒ f ig. 164
and fix it with a plastic hook (it is
⇒ f ig. 165
⇒ f ig. 165
- right.
Emergency unlocking of the loading area door
If there is a fault in the central locking, you can open the loading area door as fol-
lows:
–
Remove the control cable and pull it.
Press on the loading area door, in order to open it.
–
Press back the control cable again.
–
-left
Fig. 166 Emergency unlocking of the
loading area door