Bicycle Holder In The Luggage Compartment - Skoda ROOMSTER - 03-2010 Owner's Manual

68 Seats and Storage
Divide the luggage compartment with variable loading floor*
The luggage compartment can be divided with the variable loading floor.
– Lift up the part with the holder and secure it by sliding it into the grooves
 fig.
65.

Bicycle holder in the luggage compartment*

Install cross member
– Remove the rear seats or fold the seats fully forwards, in order to make available
the necessary space in the luggage compartment  page 60.
A at the ends of the cross member by slightly pulling up the
– Release the fixtures
B
A
securing screws .
C
Fig. 65 Divide the luggage compart-
ment
Fig. 66 Install cross member
– Position the cross member with the fixed (not pulled out) part onto the (in direction
of travel) right lashing eye and then the pull-out part
A
– Secure the fixture to both sides and lock the fixing screws
B
A
– Tighten the fixing screws up to the stop.
C
– Check the attachment of the cross member by pulling it.
WARNING
When transporting the bicycles in the luggage compartment, ensure the safety
of the passengers transported on the rear seats  page 111, "Correct seated
position for the occupants on the rear seats".
Install bicycle carrier
– Position the approved bicycle carrier on the cross member, after pulling up the
A
screw push the frame side rail (alu-part) towards the cross member and screw
A
 fig.
A
the screw into the nut 67.
A
A
– Slacken the screw on the moveable part of the bicycle carrier and pull out, then
B
position the moveable part of the carrier, depending on bicycle size, into one of the
three possible positions.
A
– Insert the screw into the desired position and tighten.
B
A
onto the left lashing eye.
A
A
in place.
C
Fig. 67 Install bicycle carrier