Diesel Particle Filter* (Diesel Engine) - Skoda OCTAVIA - 05-2010 Owner's Manual


one wheel per axle was changed.
Basic setting of the system
After changing the tyre inflation pressures, after changing one or several wheels, the
position of a wheel on the vehicle (e.g. exchanging the wheels between the axles) or
when the warning light lights up while driving, a basic setting of the system must be
carried out as follows.

Inflate all tyres to the specified inflation pressure  page 208.

Switch on the ignition.

 page 172, fig. 151
Press button
 
the button, the warning light 
is erased and the new calibration is started, which is confirmed with an audible signal

and then the warning light


If the warning light does not go out after the basic setting, there is a fault in the
system. Have the vehicle inspected by your nearest specialist garage.

Warning light lights up
If the tyre inflation pressure of at least one wheel is insufficiently inflated in comparison
to the stored basic value, the warning light
Warning light  flashes
If the warning light flashes, there is a system fault. Have the vehicle inspected by your
nearest specialist garage.
WARNING

When the warning light
avoid sudden steering and brake manoeuvres. Please stop the vehicle without
delay at the nearest possible stop and inspect the tyres and their inflation pres-
sures.

The driver is responsible for the correct tyre inflation pressures. For this
reason, the tyre inflation pressures must be checked regularly.

Under certain circumstances (e.g. sporty style of driving, wintry or unpaved
roads) the warning light 

The tyre pressure monitoring system does not take away the responsibility
from the driver for the correct tyre inflation pressure.
Using the system Safety
for more than 2 seconds. While pressing
lights up. At the same time the memory of the system
goes out.

 lights up.
 lights up, immediately reduce the speed and
can be delayed or does not light up at all.
Driving Tips
Note
The tyre pressure monitoring system:

does not replace the regular tyre inflation pressure control, because the system
cannot detect an even pressure loss,

cannot warn in case of very rapid tyre inflation pressure loss, e.g. in case of sudden
tyre damage. In this case carefully bring the vehicle to a standstill without sudden
steering movements and without sharp braking.

In order to ensure a proper functioning of the tyre inflation pressure-control
system, it is necessary to carry out the basic setting again every 10 000 km or 1x a
year.

Diesel particle filter* (diesel engine)

In the diesel particle filter the resulting soot particles are collected and
burnt during the combustion of diesel fuel.
Code 7GG, 7MB or 7MG on the vehicle data sticker, see
vehicle is equipped with a diesel particle filter. The vehicle data sticker is located on
the floor of the luggage compartment and is also stated in the Service schedule.
The diesel particle filter filters the soot particles completely from the exhaust. The soot
is collected in the diesel particle filter and burnt regularly. To assist this procedure, we
recommend not to drive regularly over short distances.
General Maintenance Breakdown assistance
Intelligent Technology 173
Fig. 152 Vehicle data sticker
 fig.
152, indicates that your
Technical Data