Table of Contents
Advertisement
WRITE BUFFER
6.Command Specification
Parameter List Length: specifies the maximum number of bytes that will be transferred during the Data Out phase.
The initiator should attempt to ensure that the Parameter List Length does not exceed the buffer capacity. If this does
occur, the drive returns a CHECK CONDITION status with an ILLEGAL REQUEST sense key set. The capacity of
the buffer can be determined from the Buffer capacity field in the Read Buffer descriptor. The Parameter List Length
must be greater than four (except in data only mode), else the drive will return a CHECK CONDITION status with an
ILLEGAL REQUEST sense key set.
SONY AIT-E Turbo drive SDX-250V series Ver.1.0
6-87
Advertisement
Table of Contents
