Freecom TAPEWARE AIT-250I Specification page 124

6.Command Specification
09h
83 08
83 0B
83 83
0Bh
43 00
45 00
47 00
48 00
4A 00
4B 00
4E 00
0Dh
00 02
0Eh
0Fh
REQUEST SENSE returns the CHECK CONDITION status only to report fatal errors for the REQUEST SENSE
command.
For example:
The target receives a non ZERO reserved bit in the command descriptor block.
An un-recovered parity error occurs on the Data Bus.
A target malfunction prevents return of the sense data.
The Allocation Length falls between block boundaries.
Following a fatal error on REQUEST SENSE, the sense data should be considered invalid. The host may attempt
recovery by selecting the drive and issuing a BUS DEVICE RESET message directly following the IDENTIFY
message. This forces the drive to do a hard reset. If the fault persists, the host should deny access to the drive.
6-72
Vendor Specific
MIC is not formatted yet
MIC is broken
MIC is exist but is not used
ABORTED COMMAND
MESSAGE ERROR–Unexpected Message phase.
SELECT OR RESELECT FAILURE-SCSI Selection/ Re-selection error.
SCSI PARITY ERROR-SCSI Parity Error detected and drive proceeded to Status
phase.
INITIATOR DETECTED ERROR MESSAGE RECEIVED.
COMMAND PHASE ERROR
DATA PHASE ERROR – Possible DMA error
OVERLAPPED COMMANDS ATTEMPTED - Host issued a new command to the drive
while a previous command was being executed.
VOLUME OVERFLOW
END-OF-PARTITION/MEDIUM DETECTED - During Write type operation.
MISCOMPARE. Not supported by the SDX-250V
RESERVED. Not used by SDX-250V
SONY AIT-E Turbo drive SDX-250V series Ver.1.0
REQUEST SENSE