Table of Contents
Advertisement
Troubleshooting
The first step in problem-solving is establishing whether the problem lies with the cartridge, the
drive, the host computer and its connections, or with the way the system is being operated.
Most modern SCSI host bus adapters locate and display attached devices when the system is
booting up. On Windows systems, if you swap or connect a product when your system is
running, you will need to reboot the system. IA32 systems also usually need to be rebooted.
UNIX systems may have pluggable drivers, which allow drives to be attached to a running
system and detected without rebooting.
If the device is not detected on boot up, there is probably a problem with the physical
hardware: cables, termination, connections, power or the host bus adapter itself. If the device
is displayed during boot up but cannot be found in the operating system, this is more likely to
be a software problem.
• If you encounter a problem during installation and need further clarification, refer to the
"Problems encountered during installation" on page 30.
• If a problem arises during testing after you have installed the drive, refer to the symptom-
based section "Testing after installation" on page 31.
• For more information about LED sequences, refer to "Understanding the LEDs" on page 33.
• For information about cartridges, refer to "Problems with cartridges" on page 36.
29
29
Advertisement
Table of Contents
