Step 4: Attach Mounting Hardware - Freecom LTO 460I Manual

Step 4: Attach mounting hardware

For many servers, no tray or rails are required. Devices simply slide into the computer's
chassis and are fixed with screws. Other servers have built-in trays or rails.
If your computer does not require special mounting hardware, proceed to "Step 5: Install the
drive" on page 15 now.
If your computer requires special rails or other hardware to install the tape drive in the empty
bay, mount them on the tape drive in this step. Mounting hardware for HP servers may be
ordered separately through your tape drive supplier.
1
Attach the appropriate rails using the four screws supplied with the rail kit.
• If you are installing in a server that requires a tray, place the tape drive in the mounting tray
supplied, as shown in Figure 4a. The tray design may not necessarily be as shown.
• If you are installing in a server that requires mounting rails, fasten the rails to the tape drive,
as shown in Figure 4b. The rail design may not necessarily be as shown.
• Some servers have snap-on mounting rails attached to the filler panel. These can be removed
and attached to the tape drive with screws.
• If your computer uses other mounting hardware, attach it to the tape drive as directed in your
computer documentation.
Note The mounting hardware supplied may not be exactly the same as shown in the illustrations.
13 13