Table Of Contents - Freecom LTO 460I Manual

Contents
Read the "Pre-Installation" and "Installing the tape drive" sections if you have to install or
replace your Ultrium Generation 2 tape drive. If you have purchased your tape drive pre-
installed in a server, go directly to the operating and troubleshooting information commencing
on page 23.
Pre-Installation
Before you start
Backup software and drivers
Installing the tape drive
Step 1: Check the SCSI connection
Step 2: Check the drive's SCSI ID
Step 3: Prepare the mounting bay
Step 4: Attach mounting hardware
Step 5: Install the drive
Step 6: Attach power and SCSI cables
Step 7: Secure the drive
Step 8: Verify installation
Using the tape drive
Your Ultrium Generation 2 tape drive
Use the correct media
Optimizing performance
Troubleshooting
Understanding the LEDs
Problems with cartridges
page 3
page 5
page 7
page 9
page 11
page 13
page 15
page 17
page 19
page 21
page 23
page 25
page 27
page 29
page 33
page 36
1 1