Changing Speaker Impedance; Bi-Amp Connection - Yamaha RX-V667 Owner's Manual

■ Bi-amp connection

This unit can be connected to speakers that support bi-amp
connections. When connecting speakers, connect the FRONT jacks
and the SURROUND BACK/BI-AMP jacks as in the diagram
below. Configure the bi-amp settings to activate connections.
FRONT
SURROUND BACK/BI-AMP
SINGLE
NOTES
• Before making bi-amplification connections, remove any
brackets or cables that connect a woofer with a tweeter. Refer to
the instruction manuals of speakers for details. When not making
bi-amplification connections, make sure that the brackets or
cables are connected before connecting the speaker cables.
• If connecting a bi-amp, then surround back speakers cannot be
used.
J
1 : Refer to the "Extended functionality that can be configured as needed
(Advanced Setup menu)" (☞p. 99) for details on the Advanced Setup menu.
■ Multi-zone audio system using the internal
amplifier of this unit
Connect the speakers in the second zone to the EXTRA SP jacks as
in the diagram below.
Zone2
ARC
DOCK HDMI OUT
ANTENNA
COMPONENT
VIDEO
FM GND AM
SIRIUS P R
75
P B
VIDEO
Y
OPTICAL COAXIAL (CD) COAXIAL ( TV ) OPTICAL AV
OUT
CAUTION
The EXTRA SP jacks of this unit should not be connected to a
Passive Loudspeaker Selector Box or more than one loudspeaker
per channel.
Connection to a Passive Loudspeaker Selector Box or multiple
speakers per channel could create an abnormally low impedance
load resulting in amplifier damage. See this owner's manual for
correct usage.
Compliance with minimum speaker impedance information for all
channels must be maintained at all times. This information is found
on the back panel of this unit.
■

Changing speaker impedance

This unit is configured for 8 Ω speakers at the factory setting.
When connecting to 6 Ω speakers, carry out the following
procedure to switch to 6 Ω. When this unit is configured for 6 Ω
speakers, 4 Ω speakers can also be used as the front speakers.
Switch this unit to the standby mode.
1
EXTRA SP
ZONE2/
PRESENCE
Press MAIN ZONE A while pressing and holding
2
STRAIGHT on the front panel.
Release the keys when "ADVANCED SETUP" is displayed on
the front panel display.
After approximately a few seconds, the top menu item is
SPEAKERS
HDMI 1 (BD/DVD) HDMI 2 HDMI 3 HDMI 4 HDMI 5 J1
COMPONENT FRONT CENTER SURROUND SURROUND BACK/BI-AMP displayed.
VIDEO
REMOTE
P R IN
SINGLE
OUT EXTRA SP
P B ZONE2/
VIDEO PRESENCE
Y +12V
0.1A MAX.
MONITOR OUT TRIGGER OUT
CENTER SINGLE CENTER
FRONT SURROUND SUR.BACK SUBWOOFER AUDIO ZONE2 FRONT SURROUND SUR.BACK 1 SUBWOOFER 2
OUT OUT PRE OUT
MAIN ZONE A
MAIN ZONE
PHONES
SILENT CINEMA
CONNECTIONS
Connecting speakers
YPAO MIC
ZONE2 ZONE CONTROL INFO MEMORY PRESET CATEGORY
FM AM
SCENE
BD
DVD TV CD RADIO
INPUT TONE CONTROL PROGRAM STRAIGHT
H
STRAIGHT
Continues to the
next page
18
En