About This Manual; Supplied Accessories - Yamaha RX-A800 Owner's Manual

About this manual

• Some features are not available in certain regions.
• This manual is created prior to production. Design and
specifications are subject to change in part as a result of
improvements, etc. In case of differences between the manual and
product, the product has priority.
d
• " HDMI1" (example) indicates the name of the parts on the
remote control. Refer to the "Remote control"
information about each position of the parts.
J
• indicates that the reference is in the footnote. Refer to the
1
corresponding numbers on the bottom of the page.
☞
• indicates the page describing the related information.
• Click on the " " at the bottom of the page to display the
corresponding page in "Part names and functions."
Front panel
Rear panel
Front panel display
Remote control

Supplied accessories

Check that you received all of the following parts.
• Remote control
• Batteries (AAA, R03, UM-4) x 2
• YPAO microphone
• AM loop antenna
• Indoor FM antenna
• VIDEO AUX input cover
■ Attaching the VIDEO AUX input cover (supplied)
To protect against dust, attach the supplied VIDEO AUX input
cover to the VIDEO AUX jacks when you do not use the jacks.
To remove the cover, push the left section of it.
(☞p. 11) for the
Attach the cover
PU SH
Remove the cover
INTRODUCTION
Using the TV OSD to operate the unit
■ Installing batteries in the remote control
When inserting batteries in the remote control, remove the
battery compartment cover from the reverse side of the remote
control, and insert two AAA batteries into the battery
compartment so that they match with the polarity markings (+
and -).
a
c
Battery compartment
cover
b
Battery compartment
Replace the batteries with new ones if the remote control can
only be operated within a narrow range.
NOTE
If there are remote control codes for external components
registered to the remote control, removing the batteries for more
than 2 minutes, or leaving exhausted batteries in the remote
control, may clear the remote control codes. If this should occur,
replace the batteries with new ones, and set the remote control
codes.
7
En