Yamaha RX-A800 Owner's Manual page 139

5 5
Set up the speaker parameters automatically (YPAO)
When all connections are complete, adjust the confi guration, sizes, and volume
balance of the speakers to provide an optimal sound fi eld. This unit is equipped with a
Yamaha Parametric Room Acoustic Optimizer (YPAO) function that adjusts the speaker
balance automatically with a simple procedure.
When using YPAO, a test tone will be output from the speakers for approximately 3 minutes to measure acoustics. Be aware of the following when
using YPAO.
• The test tone is output at high volume. Refrain from using this function at night when it may be a nuisance to others.
• Take care that the test tone does not frighten small children.
YPAO operations can be viewed on the front panel display or TV screen. TV display is used here to explain operation.
1
Check the following before using YPAO.
This unit
• The headphones are removed.
TV
• This unit is connected to the TV correctly.
• The power is turned on.
• The video input to which the video output
from this unit has been selected.
2
Place the supplied YPAO microphone at ear height in your listening
position.
• When positioning the microphone, we recommend that you use equipment that allows you
to adjust the height (such as a tripod) as a microphone stand. When using a tripod, use the
tripod screws to fi x the microphone in place.
• Measuring, for multiple listening positions, is also available. For more information, refer to
"Setting up the speaker parameters automatically (YPAO)" in the Owner's Manual.
3 Press RECEIVER A on the remote control to switch this unit on.
4
Connect the YPAO microphone to the YPAO MIC jack on the front panel.
MAIN ZONE
INPUT
This completes preparation. To achieve more accurate results, take note of the following when measuring acoustics.
• It takes approximately 3 minutes to accurately measure acoustics. Keep the room as quiet as possible while acoustics are measured.
• Wait in a corner of the room, or leave it entirely, while acoustics are measured to avoid creating an obstruction between the speakers and
the YPAO microphone.
Subwoofer
• The power is turned on.
• Volume is set to approximately half, and the
cross-over frequency (if present) is set to
maximum.
ZONE2 ZONE CONTROL INFO MEMORY
BD
DVD
PHONES YPAO MIC TONE CONTROL
YPAO microphone
SILENT CINEMA
"Mic On. View ON SCREEN" appears
on the front panel display, and then
the display at right appears on the
TV screen.
- 6 -
CROSSOVER/
HIGH CUT
VOLUME
MIN MAX
MIN MAX
Subwoofer examples
YPAO microphone
Continues to
the next page