Hdmi - Yamaha RX-A800 Owner's Manual

Problem Cause
The audio input The connected component is not
sources cannot be set to output the desired digital
played in the desired audio signals.
digital audio signal
format.
There is noise This unit is too close to other
interference from digital or radio frequency
digital or radio equipment.
frequency
equipment.
Noise/hum noise is Incorrect cable connection.
heard. Connect the audio cables properly.
A DTS-CD is being played back.
The volume cannot The component connected to the
be increased, or the output jacks of this unit is not
sound is distorted. turned on.
"Max Volume" is set to a low
value.
See
Remedy
page
Set the playback component properly —
referring to its instruction manual.
Move this unit further away from such —
equipment.
If the problem persists, the cables may be —
defective.
1) When only noise is output —
If a DTS bitstream signal is not properly
input to this unit, only noise is output.
Connect the playback component to this
unit by digital connection and playback the
DTS-CD. If the condition is not improved,
the problem may results from the playback
component. Consult the manufacturer of the
playback component.
2) When noise is output during playback or
skip operation
Before playing back the DTS-CD, display
the Input menu after selecting the input
source and set "Decoder Mode" to "DTS."
When the component connected to the —
output jacks of this unit is not turned on, the
sound may be distorted, or the volume may
decreased due to the nature of AV receivers.
Turn on all components connected to this
unit.
Set it to a higher value. 95

HDMI™

Problem Cause
The front panel An error with the HDMI
display HDMI connection has occurred.
indicator is flashing.
No picture or sound. The number of components is over
the limit.
The connected HDMI component
does not support high-bandwidth
digital copyright protection
(HDCP).
(When using HDMI The TV audio output is not
Control function) connected to this unit, or the
TV sound is not setting to match operations carried
output from this unit
out on TV is not set.
when operating the
(When using Audio Return
remote control of the
Channel function)
TV.
The Audio Return Channel
function is not working.
APPENDIX
Troubleshooting
See
Remedy
page
Try re-inserting the HDMI cable. —
Confirm that HDMI video that is not 104
supported by the unit is not being input
(Information menu → "Video
information").
Disconnect some of the HDMI components. —
Connect an HDMI component that supports —
HDCP.
Connect the TV audio output to this unit, 98
and then select the connected input source
in "TV Audio Input" (Setup menu → HDMI
→ TV Audio Input).
Make sure that your TV supports Audio 98
Return Channel.
Set the Audio Return Channel function to
on (Setup menu → HDMI → ARC (Audio
Return Channel)).
119
En