Yamaha RX-A800 Owner's Manual page 19

Check that "SP IMP." is displayed on the front panel.
3
SP IMP. -8 MIN
4 Press STRAIGHT repeatedly to select a "6ΩMIN."
Switch this unit to the standby mode, and then
5
switch it on again.
The power turns on, when the settings you made has been
configured.
■
Connecting speakers
This type of jack can connect to the following speakers or
connection.
• Front L/R speakers
• Center speaker
• Surround L/R speakers
• Surround back L/R speakers
• Bi-amp connection (Front speaker L/R speakers)
3
F R
O N
T
2 2
1
4 4
Remove approximately 0.4 in. (10 mm) of insulation
1
from the ends of the speaker cables, and twist the
bare wires of the cables together firmly so that they
will not cause short circuits.
2 Loosen the speaker terminals.
Insert the bare wire of the speaker cable into the gap
3
on the side of the terminal.
CONNECTIONS
Connecting speakers
Tighten the terminal.
4
Connecting the banana plug
Tighten the knob, and then insert the banana plug into the end of
the terminal.
Banana plug
F R
O N
T
19
En