Cvp-309 Grand Piano Type: Keyboard Stand Assembly - Yamaha Clavinova CVP-307 Owner's Manual

CVP-309 grand piano type: Keyboard Stand Assembly

CAUTION
• Be careful not to confuse parts, and be sure to install all
parts in the correct orientation. Please assemble in accor-
dance with the sequence given below.
• Assembly should be carried out by at least two persons.
• Be sure to use the correct screw size, as indicated below.
Use of incorrect screws can damage the stand.
• Be sure to tighten all screws upon completing the assem-
bly of each unit.
• To disassemble, reverse the assembly sequence given
below.
Have a Phillips-head (+) screw-
driver ready.
n
The CVP-309 grand piano type features an iAFC (Instrumental
Active Field Control) effect. This produces sound from the speaker
located on the bottom face of the Clavinova, enhancing the rever-
beration and spaciousness of the sound when you open the lid
with the longer stay (page 16).
In order to optimize the iAFC effect, please observe the following:
• Perform the automatic adjustment after you turn on the power of
the Clavinova for the first time, and after each time you re-locate
the Clavinova (page 77).
• Do not block the speaker located on the bottom face of the
Clavinova.
1
Remove all parts from the box. Confirm that all
parts shown in the illustration are included.
Main unit
CAUTION
To prevent the key cover from accidentally opening during
assembly, press down on the key cover, making sure that the
sheet (shown) remain in place.
6 × 40 mm fixing
Legs
screws × 12
6 × 20 mm fixing
screws × 4
AC power cord
Protective pad
206 CVP-309/307 Owner's Manual
How to position the main unit
Be careful not to pinch your fingers.
Protective pad
Be sure to use a protective pad to avoid a damage to the
floppy disk drive. If the drive touches the floor when you
raise the unit to lean it against the wall, too much pressure
may be applied to the drive, possibly causing serious dam-
ages to the drive.
Pedal box
• Do not place the main unit with
the rear side facing down.
• Do not lay the main unit upside
down on the floor.
• Do not position the main unit
so that its bottom is in contact
with floor.
Cord holder
CAUTION
Floppy disk drive
Floppy disk drive
1 Spread a large soft cloth such as a blanket on the
floor in front of the wall.
2 Place a protective pad on the soft cloth, so that,
when you place the main unit flat on the floor
with its keyboard side facing the wall, the pad will
be located about 10cm (a little more than four
inches) to the high key side from the floppy disk
drive as shown in the illustration. The pad will
protect the floppy disk drive so that it will not be
damaged by touching the floor.
3 As shown in the illustration, place the main unit
flat on the floor so that half of the pad underneath
protrudes from the keyboard side of the unit, and
at the same time the pad is located about 10cm to
the high key side from the floppy disk drive. Then
raise the rear of the main unit until it leans against
the wall with the keyboard side at the bottom.
Be careful not to allow the unit to fall or slip.
Place a soft cloth against the wall to protect the
unit and the wall from scratches.
CAUTION
CAUTION
Large soft cloth
Protective pad
Incorrect
Incorrect
Incorrect