Cvp-206: Keyboard Stand Assembly - Yamaha Clavinova CVP-204 Owner's Manual

CVP-206: Keyboard Stand Assembly

CAUTION
■ Be careful not to confuse parts, and be sure to install
all parts in the correct direction. Please assemble in
accordance with the sequence given below.
■ Assembly should be carried out by at least two persons.
■
Be sure to use the correct screw size, as indicated
below. Use of incorrect screws can cause damage.
■ Be sure to tighten up all screws upon completing
assembly of each unit.
■
To disassemble, reverse
the assembly sequence
given below.
1
Open the package, take out the pedal box, take out
the styrofoam pads, and place the main unit on top
of the pads.
Position the pads so that they will protect the headphone
jack and the connector panel located underneath the front
left corner, and the floppy disk drive located underneath
the front right corner.
Main unit
Phones jacks
Connector panel
Remove the parts shown below from the box.
Front panel
Rear panel
Pedal box Pedal cord
Side panel
(left)
Assembly Parts
6 x 25 mm long screws x4
6 x 16 mm short screws x4
4 x 14 mm thin screws x8
2
Attach the side panels to the pedal box.
2 Remove the vinyl tie from the folded
Side panel Side panel
(left) (left)
156
CVP-206/204
Have a Phillips-head (+)
screwdriver ready.
Floppy disk drive
Styrofoam pads
p
Side panel
(right)
AC power cord
4 x 20 mm tapping screws x5
Cord holders x2
pedal cord. Do not
remove the vinyl tie
located next to the
hole.
1 Use the four 6x25 mm
long screws to attach the
pedal box. First attach one
side panel, then attach the
Side panel Side panel
(right) (right) other side panel.
3
Attach the front panel.
1 Align and attach the front panel to the front side of the pedal box
and both side panels.
2 Secure the panel using the 4x14mm thin screws.
* Insert six screws into the smaller holes on the brackets.
4
Mount the main unit.
CAUTION
• Fingers can become pinched between the main unit and
the rear or side panels, be extra careful so as not to drop
the main unit.
• Do not hold the keyboard in any position other than the
position shown in the illustration.
Be sure to place your hands at least 10 cm from either
end of the main unit when positioning it.
At least At least
10 cm 10 cm
5
Fix the main unit.
1 Center the main unit to produce equal clearance on the left and
right sides.
2 Use 6x16 mm short
screws to secure the
main unit from the rear.
* Use the front hole on
the front brackets to
attach the screws.