Ignition & Usage; Ignition; To Extinguish - Weber Q-320 Owner's Manual

iGnition

Note: Summary ignition instructions are posted on the cart leg under the control knobs.
m dAnGeR
failure to open the lid while igniting the barbecue's burners,
or not waiting five minutes to allow the gas to clear if the
barbecue does not light, may result in an explosive flare-up
which can cause serious bodily injury or death.
Note : The ignition system ignites the burners with a spark from the igniter electrode
inside the ignition chamber. You generate the energy for the spark by pushing the
ignition button until it clicks.
A) Open the lid (1).
B) Make sure all burner control knobs are turned OFF (2). (Push each knob in and turn
clockwise to ensure it is in the OFF position.)
m wARninG: the burner control knobs must be in the off
position before turning on the liquid propane cylinder valve.
if they are not in the off position, when you turn on the lP
cylinder valve, the "excess gas flow control" feature will
activate, limiting the flow of gas from the lP cylinder. if this
should occur, turn off the lP tank valve and burner control
knobs. start over.
m dAnGeR
when the "excess gas flow control" feature is activated,
a small amount of gas is still flowing to the burners. After
turning off the cylinder and burner control knobs, wait at
least five minutes for the gas to clear before attempting to
light the barbecue. failure to do so may result in an explosive
flame-up, which can cause serious bodily injury or death.
C) Turn the gas on by turning the cylinder valve counterclockwise (3).
m wARninG: do not lean over the open barbecue when
igniting the barbecue.
D) Push in the large control knob for the outside burner and turn it to START/HI (4).
E1) Q300 with push-button ignition: Push the ignition button so that it clicks and ignites
the burner (5).
OR
E2) Q320 with electronic ignition: Push the ignition button (5). You will hear it click
continually until burner ignites.
F) Check that the burner is lit by looking down through the cooking grate (6). You
should see a flame.
m wARninG: if the burner does not light, turn the burner
control knob to off and wait five minutes to let the gas
clear before you try again or try to light with a match.
G) After the outside burner is lit, you can turn on the inside burner. Push in the small
control knob and turn it to START/HI (7). The inside burner will then be ignited by
the outside burner.
◆

to eXtinGuish

Push in and turn each burner control knob clockwise to the OFF position. Turn gas
supply OFF at the source.
◆
28
IGNITIoN & USAGE
1
5
off
6
3
7
2
stARt/hi
6
6
4
medium low