VTech i5888 User Manual page 13

Your i 5881 Handset comes registered to the
Base Unit. To register additional VT 5820
Handsets, follow these steps:
Enter Base ID Code
1. After charging the Handset, remove it
from its Charge Cradle; the screen will
display:
alternating with this screen:
2. If, after charging the Handset, you see:
3. Press NEW. You will now see the
ENTER BASE ID screen as described
in step 1.
4. Find the BASE ID Code by doing the following: (the Base must be in idle
(OFF) mode)
A. At the Base, press MENU
B. Scroll down to DISPLAY BASE-ID
C. Press OK. The Base screen will display the 15-digit ID Code.
Afterwards, it will return to the idle screen.
5. Enter the 15-digit Base ID Code into the Handset; then press OK.
NOTE: The 15-digit BASE ID Code may contain numbers and characters,
including 0 through 9,
6. Wait approximately 15 to 60 seconds. You will hear confirmation beeps
from the Base and Handset. The newly registered Handset will now assign
itself the lowest Handset number not previously assigned to a different
system Handset (1 through 6).
7. If the Handset displays REJECTED BY
BASE or continues to display
SEARCHING FOR BASE for well
beyond 60 seconds, try the registration
process again by repeating the above
steps.
Congratulations! You can now enjoy the benefits of your VTech Multi-Handset
system.
Registration and Operation
and #. Make sure you enter all 15 digits.
*
13