Visioneer Strobe XP 470 User Manual page 137

130 V S
ISIONEER TROBE
Error
Problem Description
Code
0 Scanner is not connected to the
computer. (The LED does not
flash "E" and the status light
remains green.)
1 The scanning hardware in the
body of the scanner has
malfunctioned.
2 The scanning hardware in the
ADF portion of the scanner has
malfunctioned.
3 The main board in the scanner
has malfunctioned.
4 The CCD in the body of the
scanner has malfunctioned.
5 The CCD in the ADF portion
of the scanner has
malfunctioned.
6 The scanner's cover is open.
7 The lamp in the scanner body
has malfunctioned.
8 The lamp in the ADF portion of
the scanner has malfunctioned.
9 Paper jam
XP 470 S U '
CANNER SER S
A cable may be loose. Check that the scanner's cables are
correctly attached to the computer. If the scanner still does
not connect, re-boot the computer.
Re-boot your computer. If the problem persists, contact
Visioneer Technical Support.
Re-boot your computer. If the problem persists, contact
Visioneer Technical Support.
Re-boot your computer. If the problem persists, contact
Visioneer Technical Support.
Re-boot your computer. If the problem persists, contact
Visioneer Technical Support.
Re-boot your computer. If the problem persists, contact
Visioneer Technical Support.
Close the scanner cover and make sure it attaches completely.
Make sure that the lamp has not been turned off manually.
See the steps on page 92 to turn the lamp on and off. Re-boot
your computer. If the problem persists, contact Visioneer
Technical Support.
Make sure that the lamp has not been turned off manually.
See the steps on page 92 to turn the lamp on and off. Re-boot
your computer. If the problem persists, contact Visioneer
Technical Support.
See "Clearing Paper Jams" on page 125.
G
UIDE
Solution