Gigabyte C7V7-CSI User Manual page 17

10) F_ USB1 / F_USB2 (Front USB Connector)
Be careful with the polarity of the front USB connector. Check the pin assignment carefully while
you connect the front USB cable, incorrect connection between the cable and connector will make
the device unable to work or even damage it. For optional front USB cable, please contact your
local dealer.
11) BAT (Battery)
Pin No.
1
1
9
2
3
4
10
2
5
6
7
8
9
10
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type recommended
by the manufacturer.
Dispose of used batteries according to the manufacturer's
instructions.
If you want to erase CMOS...
1. Turn off the computer and unplug the power cord.
2. Gently take out the battery and put it aside for about one
minute. (Or you can use a metal object to connect the positive
and negative pins in the battery holder to makethem short for
five seconds.)
3. Re-install the battery.
4. Plug the power cord in and turn on the computer.
- 17 -
Definition
Power (5V)
Power (5V)
USB DX-
USB Dy-
USB DX+
USB Dy+
GND
GND
No Pin
NC
Hardware Installation