Gigabyte C7V7-CSI User Manual page 29

DRAM Timing
Auto By SPD
Manual
SDRAM CAS Latency
Set SDRAM CAS Latency to DDR / DDR2.5 / 4
Bank Interleave
Disabled
Enabled
Precharge to Active (Trp)
Set precharge to active to 4T
Active to Precharge (Tras)
Set Active to precharge to 07T
Active to CMD (Trcd)
Set Active to CMD to 4T
REP to ACT / REF(Trfc)
Set REP to ACT / REF to 21T
ACT(0) to ACT(1) (TRRD)
Set ACT(0) to ACT(1) to 3T
Read to Precharge (Trtp)
2T
3T
Write to Read CMD (Twtr)
1T/2T
2T/3T
Write Recovery Time (Twr)
Set write recovery time to 2T/3T/4T/5T
DRAM Command Rate
2T Command
1T Command
RDSAIT mode
Auto
Manual
RDSAIT selection
Set RDSAIT to 03
Set DRAM timing auto by SPD.(Default Value)
Set DRAM timing by manually.
Set bank interleave to Disabled.(Default Value)
Set bank interleave to Enabled.
(Default value:4T)
(Default value:07T)
(Default value:4T)
(Default value:21T)
(Default value:3T)
Set Read to Precharge is 2T.(Default value)
Set Read to Precharge is 3T.
Set write to read CMD is 1T/2T.(Default value)
Set write to read CMD is 2T/3T.
(Default value:4T)
Set DRAM Command rate to 2T. (Default value)
Set DRAM Command rate to 1T.
Auto detect RDSAIT mode. (Default value)
Set RDSAIT mode by manually.
(Default value:03)
- 29 - BIOS Setup