TP-Link TD-W8968 User Manual page 31

TD-W8968
DNS Server/ Secondary DNS Server: Here you can set DNS Server (at least one) manually.
The Route will use this DNS Server for priority.
Default Gateway: select a WAN Interface from the drop-down list as the IPv4 default
gateway.
MTU (bytes): Maximum Transmission Unit Size. Check this box then you can change the MTU
size. The default MTU value is 1500 Bytes. It is not recommended that you change the default
value unless required by your ISP.
Enable NAT: This technology translates the IP addresses of a local area network to a different
IP address for the Internet. If this Modem Router is hosting your network's connection to the
Internet, please select the check box. If another Router exists in your network, you don't need
to select the option.
Enable Fullcone NAT: It is a type of NAT, if not enabled, the default NAT will act.
Enable SPI Firewall: A SPI firewall enhances network's security. Select the option to use a
firewall, or else without a firewall.
Enable IGMP Proxy: IGMP (Internet Group Management Protocol) is used to manage
multicasting on TCP/IP networks. Some ISPs use IGMP to perform remote configuration for
client devices, such as the Modem Router. The default value is disabled, and if you are not
sure, please contact your ISP or just leave it.
Click the Save button to save the settings.
4.4.1.2 Dynamic IP
Select this option, the Modem Router will be able to obtain IP network information dynamically
from a DHCP server provided by your ISP.
300Mbps Wireless N USB ADSL2+ Modem Router User Guide
22