Table of Contents
Advertisement
D. BACKUP BATTERY REMOVAL
1) Remove the backup battery from the main/LCD PWB unit.
* When installing the battery, be careful of the installing direction and
install it diagonally from the lower side of the battery holder spring.
E. MAIN/LCD PWB UNIT REMOVAL
1) Remove the ANT dust-proof sheet (a) and the submersion sheet (b),
and remove the main/LCD PWB unit (c).
(c)
* When attaching the ANT dust-proof sheet (a), fit it with the RF external
antenna connector with the main/LCD PWB silk section as the refer-
ence.
* When attaching the submersion sheet (b), attach it inside the bump area.
(b)
* When attaching the PWB unit, rotate the main PWB and the LCD
PWB 180 degrees in the arrow direction to wind the flat cable.
CONFIDENTIAL
2) Remove the camera shield case unit from the main/LCD PWB unit,
3) Remove the connector (a). Disengage the pawl, and remove the
(a)
(b)
F. SUB LCD REMOVAL
1) Remove the sub LCD from the sub LCD holder unit.
(a)
TM200 DISASSEMBLY AND REASSEMBLY
3 – 2
and remove the camera flexible unit.
Disengage the pawl, and remove the sub LCD unit.
Disconnect the connector.
main/LCD unit. Disconnect the connector (b).
(b)
(a)
* Hold the both ends of the sub LCD as shown in the figure,
and never press TAB (a).
(a)
Advertisement
Table of Contents
